Easily Upgrade HAMA WX and DD Sensors to the EX-Q

We have experienced near 100% success rate upgrading DD and WX sensors to the EX-Q. Our dedicated technical support team knows what questions to ask to assure that your upgrade is as simple as:

1. Adding the appropriate connector to the EX-Q Sensor
2. Installing the EX-Q on the robot – our Sensor Alignment Card now available to make EX-Q setup foolproof. Find out how to receive yours free!
3. Re-teaching the robot for Z, Radius, and Theta
4. Mapping wafers
5. Making minor software adjustments as needed

Contact technical support to learn more about upgrading to the EX-Q wafer mapping sensor at 800-366-9131 or 503-495-2200
or via e-mail at CSinfo@cyberoptics.com

 

< Back to Introduction